ISO 105-G03
Textiles — Tests for colour fastness — Part G03: Colour fastness to ozone in the atmosphere
ISO 438
Paper — Determination of bulking thickness and apparent density- withdrawn
ISO 534
Paper and board — Determination of thickness, density and specific volume
ISO 535
Paper and board — Determination of water absorptiveness — Cobb method
ISO 11092
Textiles — Physiological effects — Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded-hotplate test)
ISO 11607
Packaging for terminally sterilized medical devices — Part 2: Validation requirements for forming, sealing and assembly processes
ISO 11998
Paints and varnishes — Determination of wet-scrub resistance and cleanability of coatings
ISO 12048
Packaging — Complete, filled transport packages — Compression and stacking tests using a compression tester
ISO 12572
Hygrothermal performance of building materials and products — Determination of water vapour transmission properties — Cup method
ISO 12625
Test methods for determining the width-related breaking force, breaking elongation, and work holding capacity of tissue paper and tissue products.
ISO 13355
Packaging — Complete, filled transport packages and unit loads — Vertical random vibration test
ISO 13937
Textiles — Tear properties of fabrics
ISO 13939-2
Foil bearings — Performance testing of foil journal bearings — Testing of static load capacity, friction coefficient and lifetime
ISO 15105
Plastics — Film and sheeting — Determination of gas-transmission rate
ISO 15106
Specifies an instrumental method for determining the water vapor transmission rate of plastic films, plastic sheeting and multilayer structures including plastics using a moisture sensing sensor.
NOTE The method provides rapid measurement over a wide range of water vapor transmission rates.
ISO 1524
Paints, varnishes and printing inks — Determination of fineness of grind
ISO 1924
Paper and board - Determination of tensile properties - Constant rate loading method
ISO 1974
Paper — Determination of tearing resistance — Elmendorf method
ISO 21974
Naturalistic driving studies — Vocabulary — Part 1: Safety critical events
ISO 2247
Packaging - Packages and load units ready for shipment - Low fixed frequency vibration test
ISO 2248
Packaging — Complete, filled transport packages — Vertical impact test by dropping
ISO 2249
Acoustics — Description and measurement of physical properties of sonic booms
ISO 2469
Paper, board and pulps — Measurement of diffuse radiance factor (diffuse reflectance factor)
ISO 2470
Paper, board and pulps — Measurement of diffuse blue reflectance factor — Part 1: Indoor daylight conditions (ISO brightness)
ISO 2471
Paper and board — Determination of opacity (paper backing) — Diffuse reflectance method
ISO 2493
Paper and board — Determination of bending resistance — Part 1: Constant rate of deflection
ISO 2528
Sheet materials — Determination of water vapour transmission rate (WVTR) — Gravimetric (dish) method
ISO 2556
Plastics — Determination of the gas transmission rate of films and thin sheets under atmospheric pressure — Manometric method
ISO 2758
Paper — Determination of bursting strength
ISO 2759
Board — Determination of bursting strength
ISO 2813
Paints and varnishes — Determination of gloss value at 20°, 60° and 85°
ISO 2814
Paints and varnishes — Comparison of contrast ratio (hiding power) of paints of the same type and colour
ISO 2913
Wool — Colorimetric determination of cystine plus cysteine in hydrolysates
ISO 3034
Corrugated fibreboard — Determination of single sheet thickness
ISO 3035
Corrugated fibreboard — Determination of flat crush resistance
ISO 3037
Corrugated fibreboard — Determination of edgewise crush resistance (unwaxed edge method)
ISO 3688
Pulps — Preparation of laboratory sheets for the measurement of diffuse blue reflectance factor (ISO brightness)
ISO 3781
Paper and board — Determination of tensile strength after immersion in water.
ISO 4586-2
High-pressure decorative laminates (HPL, HPDL) — Sheets based on thermosetting resins (usually called laminates) — Part 2: Determination of properties
ISO 4593
Plastics — Film and sheeting — Determination of thickness by mechanical scanning
ISO 4638
Polymeric materials, cellular flexible — Determination of air flow permeability
ISO 5263
Pulps — Laboratory wet disintegration
ISO 5267
Pulps — Determination of drainability
ISO 5269-1
Pulps — Preparation of laboratory sheets for physical testing — Part 1: Conventional sheet-former method
ISO 5269-2
Pulps — Preparation of laboratory sheets for physical testing — Part 2: Rapid-Köthen method
ISO 5626
Paper — Determination of folding endurance
ISO 5627
Paper and board — Determination of smoothness (Bekk method)
ISO 5636
Paper and board — Determination of air permeance
ISO 5893
Rubber and plastics test equipment — Tensile, flexural and compression types (constant rate of traverse) — Specification
ISO 6383-2
Plastics — Film and sheeting — Determination of tear resistance — Part 2: Elmendorf method
ISO 6504
Paints and varnishes — Determination of hiding power
ISO 6941
Textile fabrics — Burning behaviour — Measurement of flame spread properties of vertically oriented specimens
ISO 7263
Corrugating medium — Determination of the flat crush resistance after laboratory fluting
ISO 7500-1
Metallic materials — Calibration and verification of static uniaxial testing machines — Part 1: Tension/compression testing machines — Calibration and verification of the force-measuring system
ISO 7668
Anodizing of aluminium and its alloys — Measurement of specular reflectance and specular gloss of anodic oxidation coatings at angles of 20°, 45°, 60° or 85°
ISO 7765
Plastics film and sheeting — Determination of impact resistance by the free-falling dart method
ISO 8295
Plastics — Film and sheeting — Determination of the coefficients of friction
ISO 8791
Paper and board — Determination of roughness/smoothness (air leak methods) — Part 1: General method
ISO 9237
Textiles — Determination of the permeability of fabrics to air
ISO 9283
Manipulating industrial robots — Performance criteria and related test methods
ISO 9290
Textiles — Woven fabrics — Determination of tear resistance by the falling pendulum method
ISO 9895
Paper and board — Compressive strength — Short-span test
ISO 9073-7
Textiles — Test methods for nonwovens — Part 7: Determination of bending length
